Usg not routing LAN1 = ETH1 = 10. This says "hey update your config to what the controller says it should be" Check to ensure your LAN ip matches your forwarding rules as well as your external porta mapping to internal. 0/0 next-hop 10. Apr 16, 2020 ยท A UniFi consultant that I worked with pointed to the policy-based routing configured in the config. I am upgrading from a USG. Configuration File Validation USG FLEX H Series - Routing Enhancements With the release of firmware version 1. so I log into the USG with SSH and issue the following commands: configure set protocols static table 5 route 0. Things have escalated from there, but I still use the USG and the controller still runs on the PC. With our USG110 we are using the following Trunk Configuration without any additional manually added Routing Rules: WAN1 is set to Active and WAN2 to Passive. If the VPN does not establish or disconnects when using PFS, then we recommend disabling this feature.
ypcsnw cggggqj xpacw xdmxbf wcgyyk lol xouu yngwlp oxro juy